The ION STICK Electrostatic Water Treatment

THE ION STICK Alternative Environmental Water Treatment

Specification for Water Treatment:

ELECTROSTATIC WATER TREATMENT:

The use of an electrostatic device designed to prevent waterside problems including scaling, deposition and microbiological fouling; it is to be retrofitted into any aqueous recirculating heat transfer system where there is continuous non-turbulent flow. It can be applied with or without chemicals, wholly or in part, to meet the desired objectives.

The water treatment programs must coincide with the criteria and recommendations outlined by the supplier of the electrostatic product. Performance necessitates routine system maintenance and management.

Furnish and install a factory assembled electrostatic water treatment product that measures a length of approximately 54cm. (21½ inches) or 42cm. (16½ inches) at the probe end. The probe is to have an approximate diameter of 2.8cm. (1.1 inches) with a 40 MIL Teflon covering that is dialectically sealed between a metal cap and a metal 3.8cm. (1½ inch) NPT threaded male connection.
Unit to include a self-monitoring power pack in a NEMA 12 general purpose plastic enclosure; a solid state transformer with an adjustable screw potentiometer to provide a V.D.C. output of ~ 8900 across the high tension and ground terminals.
Approximately nine feet of flexible water-tight conduit must house the wiring between the probe section and the power pack. Metal and water resistant connections are to be applied at both ends of the conduit.
The power source to the power pack is to be specified at either 115 V.A.C./60 Hz single phase or 230 V.A.C./50 Hz single phase. Fuse protection and pilot light indicator are necessary features. No more than 10 watts of power is to be consumed with this product.
The electrostatic treatment product must be CSA approved and/or UL listed to ensure safety standards.
A minimum one year warranty against material workmanship is recommended.
The product should be available in at least two different materials of construction; a brass model for general and routine applications and a 316 stainless steel model suitable for specified conditions or situations.